General experimental procedures
Nuclear magnetic resonance (NMR) spectra were obtained using Bruker AVANCE-300 spectrometer (Bruker, Germany). Chemical shifts are given as δ (ppm) using TMS as the internal standard. Semipreparative HPLC was performed on a KNAUER liquid chromatography system with a quaternary pump (Smartline Pump 1000) and a semi-prep c18 column (onyx monolithic; 100×10 mm). Diode array detector (Smartline DAD 2800) and EZ Chrom Elite software were used for the detection and processing of data, respectively. Observation of the plates was carried out under UV CAMAG spectrometer (CAMAG instruments, Berlin, Germany) at 254 nm. Column chromatography was conducted with Si gel 230–400 mesh (Merck, Germany). Analytical TLC was performed on Silica gel 60 F254 (Merck, Germany) and preparative TLC was performed on Silica gel 60 GF254 (Merck, Germany).
Plant material
The roots of S. pachycarpa were collected and identified in April 2015, from Khorasan-Razavi province, the road of karde. A voucher specimen (No. 13247) was deposited in the herbarium of the School of Pharmacy, Mashhad University of Medical Sciences.
Extraction and isolation
The total plant extract was obtained from the dried and milled roots of
Sophora pachycarpa (500 g) with MeOH (for three days per extraction) using the maceration method at ambient temperature. The combined extracts were concentrated to dryness under vacuum pressure to afford 50 g of a brown residue. A part of the extract (35 g) was subjected to silica gel chromatography (230–400 mesh, 55 × 5 cm) using petroleum ether–ethyl acetate and ethyl acetate–methanol [(1:0 to 0:1 and 1:1, 0:1, v/v) × 2L] as a gradient solvent system to give ten fractions (Fr. 1–10). Fraction 4 was further purified by PTLC to give 1 (5 mg, Rf 0.33) using chloroform/methanol (3:0.5) system to yield a yellow powder. Other compounds (2-5) were isolated as previously described (
10) using Sephadex LH-20 (25-100 μm, Fluka) CC (MeOH) and high-performance semi-preparative liquid chromatography with a gradient of MeOH–H
2O (20:80, v/v) on an Onyx monolithic semi-prep C18 (100 × 10 mm) column. The structures of the compounds were confirmed by comparison of
1H-and
13C-NMR spectra with those of previous reports (
10-
14).
Cancer cell lines
Human cervical (HeLa), colon (HCT116), ovarian (A2780), and lung (A549) cancer cells, obtained from Biotechnology laboratory stocks, Biotechnology research center (Mashhad, Iran) and National Cell Bank of Iran (NCBI), Pasteur Institute of Iran, Tehran (Iran).
Cytotoxic assay
Compounds 1-5 were tested against HeLa, HCT116, A2780and A549 human cancer cell lines using a nonfluorescent substrate, AlamarBlue® (BioSource Invitrogen, Paisely, UK) and subjected to cell viability assay as described with some modification (
15). The cell lines were cultured in RPMI-1640 medium (Cambrex Bioscience) supplemented with 10% fetal bovine serum (FBS), and 1% penicillin/streptomycin at 37 °C in an atmosphere of 95% O
2 and 5% CO
2. The cells were seeded in 96-well microplates (1 × 10
4 cells/100 µL in each well) and cultivated for 24 h before the addition of test compounds. Three wells for each concentration were seeded and triplicate plates were used. The test compounds were dissolved in dimethyl sulfoxide (the final amount of DMSO per well was maintained at 0.1%V/V) and their concentrations adjusted to 100, 50, 25, 12.5, 6.25 μM through dilution with the growth medium. Then, the cells were incubated with the different concentrations of the test compounds, positive control and cell culture medium alone as a negative control for 48 h. After that, 10 μL of alamarBlue® reagent was added to the attached cells and incubated for another four hour. The absorbance was measured at 600 nm using an ELISA microplate reader (Epoch; Bio Tek, Winooski, VT, USA), and the percent viability of the cells was investigated relative to the negative control that was exposed to the culture medium without compounds of the plant. Then, IC
50 values were calculated by nonlinear regression analysis using GraphPad Prism (Version 6.0) software. The positive control was vorinostat (purity ≥ 98%; Sigma-Aldrich, USA).
Whole-cell HDAC inhibition assay
The cellular HDAC assay was based on an assay published by Marek
et al. (
16). HCT116 and HeLa human cancer cell lines were seeded in 96-well tissue culture microplates (1.5 × 10
4 cells/90 µL culture medium in each well). After 24 h, the cells were incubated for 18 h with increasing concentrations of test compounds, vorinostat as positive control and cell culture medium alone as a negative control. The test compounds were dissolved in dimethyl sulfoxide (the final amount of DMSO/well was maintained at 0.1% V/V) and their concentrations adjusted to 70, 40, 20, 5, 1 μM through dilution with the growth medium. The reaction was started by adding 10 µL of 3 mM Boc-Lys (ε-Ac)-AMC (Bachem, Switzerland) to each well at a final concentration of 0.3 mM. The cells were incubated with the Boc-Lys (ε-Ac)-AMC for 3 h under cell culture conditions. After this incubation, 100 µL/well of stop solution (25 mM Tris-HCl (pH 8), 137 mM NaCl, 2.7 mM KCl, 1 mM MgCl
2, 1% NP40, 2.0 mg/mL trypsin, 10 µM vorinostat) was added and the mixture was treated for three hour under cell culture conditions. The final volume of the assay is 210 µL in all the wells. After that, the solution was transferred into a black 96-well microplate with flat clear bottom and fluorescence intensity was detected at an excitation of 360 nm and emission of 470 nm in a NOVO star microplate reader (BMGLabTech, Offenburg, Germany).
Trypsin inhibitory assay
Trypsin inhibition assay was carried out according to the method of Zwick
et al. (
17). Reactions were carried out in 96-well microplates in triplicate. 2.0 mg/mL trypsin was dissolved in assay buffer (25 mM Tris at pH 8.0 adjusted with HCl, 137 mM NaCl, 2.7 mM KCl, 1 mM MgCl
2) with vorinostat (10 μM) and added to each microplate well, except for blanks. Test compounds were diluted in DMSO and added at a final concentration of 70 μM (1% DMSO) in each well. The reaction was initiated by the addition of BOC-Lys-AMC substrate (Bachem, Switzerland). The plate was then incubated at 25 °C for 45 min. Trypsin inhibition was calculated by comparing the amount of deacetylated substrate between control and test samples. The relative amounts of deacetylated substrate were obtained by fluorescence reading with excitation at 360 nm and emission at 470 nm. Caffeic acid was used as a positive control.
Molecular docking studies
The crystal structures of HDAC8 [PDB entry code: 1T64] was obtained from the Protein Data Bank (PDB). The co-crystallized ligands, all water and non-interacting ions were removed from the receptor. Then all missing hydrogens and sidechain atoms were added. In the next step, Gasteiger charges were calculated for the system. In the final step, by using OPLS3, the receptor was minimized and optimized. The active site of HDAC8 was defined as 10.0 Å radius circles around co-crystal ligand (trichostatin A). Other docking parameters utilized in the program were kept default. For ligand setup, these ligands were optimized with the OPLS3 (Optimized Potential for Liquid Simulations) level. Molecular docking studies were performed with XP module of Glide (Schrödinger LLC, New York). Visualizing was performed by chimera (18). The prediction of drug like properties was carried out using QikProp and pharmaceutical parameters about oral bioavailability were reported.