Chemicals
The following drugs were used throughout the study: NPH insulin was purchased from Wolfratshausen (Germany). Streptozocin was purchased from Sigma (USA) and thiopental was purchased from Sandoz (USA). Streptozocin was dissolved in 0.1 M citrate buffer (pH 4.5). NPH insulin, thiopental, and streptozocin (60 mg/kg) were administered intraperitoneally, while the extract was administered orally by gavage.
Animals
The experimental animals were male Sprague–Dawley rats (200–300 g body weight) procured from Shiraz University of Medical Sciences. They were maintained under standard conditions (temperature 22 ± 2 °C, relative humidity of 60 ± 5% and 12 h light/dark cycle). They had free access to standard pellet diet and water ad libitum. The Institutional Animal Ethics Committee of Shiraz University of Medical Sciences approved the experimental protocol. All the animals received animal care according to the criteria outlined in the «Guide for the Care and Use of Laboratory Animals».
Plant Material
Amygdalus lycioides Spach branches were collected near Shiraz (Bavanat), Iran, in June 2013. It was identified by a specialist botanist. A voucher specimen (V. No. 765) was deposited in the Herbarium of Shiraz University of Medical Science, Iran. The air-dried plant material was stored in dark conditions and then blended to make soft powder.
Extraction
The powder (1000 g) of Amygdalus lycioides Spach were pre-treated with ethanol 50% (w/v) for 48 h in room temperature. The extract was separated by filtration and solvent was evaporated to dryness under vacuum to 55 °C, yielding a dried residue (3.8 g). Ten g of dried residue was solved in 100 mL water to make the extract.
Preliminary phytochemical screening of Amygdalus lycioides
The preliminary phytochemical analysis including flavonoids, tannins and alkaloids determination tests was carried out for the extract of
Amygdalus lycioides, using standard phytochemical methods (
15).
Standardization of the plant according to total flavonoids contents
In order to make the standardization of the plant according to total flavonoids contents, we determined total flavonoids in the plant extract. Aluminum chloride method was used for the determination of the total flavonoid content of the sample extracts (
16). Aliquots of extract solutions were taken and made up the volume 3 mL with methanol. Then 0.1 mL AlCl3 (10%), 0.1 mL Na-K tartrate and 2.8 mL distilled water were added sequentially. The test solution was vigorously shaken. Absorbance at 415 nm was recorded after 30 min of incubation. A standard calibration plot was generated at 415 nm using known concentrations of quercetin. The concentrations of flavonoids in the test samples were calculated from the calibration plot and expressed as mg quercetin equivalent/g of sample.
Diabetes Induction
After overnight fasting, diabetes was induced by intraperitoneal injection of streptozocin dissolved in 0.1 M cold sodium citrate buffer (pH 4.5) at a dose of 60 mg/kg which can induce type I diabetes mellitus (
17). Blood samples were taken from tail vein before and after the start of experiment. Blood glucose was determined using a glucose monitoring (accu-check, Roche, USA). After 4 days, the time for the development of diabetes, the rats with moderate diabetes having hyperglycemia (blood glucose range of above 250 mg/dL) were considered as diabetic rats and used for the future experiments.
Experimental groups
Animals were randomly divided into six groups and each group contained 10 diabetic rats. Group I served as solvent-treated diabetic control group and group II served as insulin group that received insulin NPH (3 unit) subcutaneously each day. In groups III, IV, V and VI, plant extract (125, 250, 500 and 1000 mg/kg, respectively) were administrated once daily orally along with normal food.
Treatment of experimental animals with plant extracts or insulin was initiated 4 days post streptozocin injection and drug administration was carried out once daily for 14 days. Food and water were made freely available. The initial and final body weights were measured. Blood samples for glucose determination were obtained from the tail tip of 12 h fasted rats on day 0 (before streptozocin administration) and 4, 11 and 18 days after streptozocin injection. On the 18th day post streptozocin injection, the animals were fasted for 12 h. After fasting blood glucose determination from the tail tip of rats, glucose (2 g/kg) was fed to rats. Blood was withdrawn from the tail vein at 120 min and glucose levels were estimated (oral glucose tolerance test: OGTT). After that rats were anaesthetized using thiopental and sacrificed by decapitation. Blood was collected from the heart in a dry tube and allowed to coagulate at ambient temperature for 30 min. Serum was separated by centrifugation at 2000 rpm for 10 min, then aspartate transaminase (AST), alanine aminotransferase (ALT), alkaline phosphatase (ALP), cholesterol, triglycerides, HDL, LDL, Na, K, creatinine, urea, and total protein levels in different groups of rats were determined.
Stereological study
At the end of experiment, the animals were dissected and the pancreas were removed and weighed. Primary volume V (primary) of the pancreas was measured using the immersion method (
18). In some cases, shrinkage could occur after fixation and tissue preparation. These factors may have effects on the quantitative estimation; therefore, it seems necessary to measure tissue shrinkage (
19, 20). Orientator method to obtain isotropic uniform random (IUR) sections of pancreas was used for estimation of pancreas shrinkage. In this method, the pancreas was located at the center of a circle and a number was selected randomly, then the pancreas was sectioned. Each portion of pancreas was located on the other circle and a new number was selected, and then the pancreas was cut into slabs. Another portion of pancreas was located on the same circle and sectioned into slabs in a new axis. In this procedure we obtained about 8-12 slabs of pancreas. For estimation of pancreas shrinkage, two circles of tissue were punched by trocar and measured pre-fixing radius (r before) and post-fixing radius (r after) (
Figure 1A).
Volume shrinkage of pancreas was estimated by using the following formula:
Volume shrinkage = 1 – (r after2 /r before2) 1.5
After volume of shrinkage was estimated, the tissue was fixed by buffer formaldehyde, embedded by paraffin, sectioned and stained by modified aldehyde fuchsia (
21). The 5 µm thin serial sections and 20 µm thick pair serial sections were cut in order to estimate the volume and number of islets and β-cell, respectively.
The final volume was estimated by following formula:
Final volume: Vprimary × (1 - volumeshrinkage)
Volume Density of the Pancreatic Islets
The volume density of islet was estimated by using the point-counting method. In this method, the 5 µm microscopic slide of 8 to 10 sections from each tissue was analyzed using a video microscopy system (E-200, Nikon, Tokyo, Japan) linked to a video camera, and a computer, with a flat monitor. On each section, 6 to 8 fields were randomly selected by systematic random manner.
The pointing test grids were superimposed on the images and viewed on the monitor by means of the stereology software and analyzed using a microscope (
Figure 2). This software was designed by our research center (Stereological Research Laboratory, Shiraz University of Medical Sciences, Shiraz, Iran).
The number of the points hitting the reference space (the pancreas) and the islets estimated the volume density (Vv) of the pancreatic islet was estimated using the following formula:
Vv = Pislet / Preference
Where, P (islet) and P (reference) were the number of the points falling on the islet’s profile and on the reference space, respectively. The following formula was used to estimate the final islet volume:
Vislets = Vv × V final volume
by multiplying the volume density of the islet by the final volume of the pancreas.
Number of β- cells
In order to estimate the number of β-cell, it is necessary to obtain the numerical density of the β-cells using the optical disector method (
Figure 3). In this method, the 20 µm microscopic slide was analyzed using a video microscopy system (E-200, Nikon, Tokyo, Japan) linked to a video camera, a computer, a flat monitor, and a microcator (MT-12, Heidenhain Traunreut, Germany). The height of disector or “h” is distance between two pair sections and the first 5 μm of the section thickness was ignored to avoid biased counting (guard zone). To determine the volume density of β-cell, 8-10 microscopic fields were selected through systematic uniform random sampling. To estimate the β-cell, we used about 90 systematic frames applied on pancreatic islands. Nuclei of β-cells were considered as the whole cell. The cells whose nuclei were completely or partly inside the counting frame or touched the upper and right lines were counted (ΣQ). Only the nuclei did not appear at the beginning of the disector height and appeared in the following optical scan of the disector height were counted.
The numerical density (NV) was estimated using the optical disector method and the following formula:
Nv = ∑Q/h. a/f. ∑p
Where:
∑Q: is the number of β-cell
h: is the height of optical dissector
a/f: area of the test frame
∑p: is the number of test frame on the islet profile
To estimate the number of the β-cell, the following formula was used:
N β-cell = Nv. V islet
Statistical analysis
The results were analyzed using One-Way analysis of variance (ANOVA) followed by Tukey post-hoc test. P < 0.05 was considered statistically significant.